> For the complete documentation index, see [llms.txt](https://quakecore-1.gitbook.io/quakecore-network/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://quakecore-1.gitbook.io/quakecore-network/guide/how-reset-quake-miner-to-configure-stage.md).
# How Reset Quake Miner to Configure Stage
Video Guide:
After successfully configuring the Quake miner, the miner's Quakecore-AP WiFi disappears, indicating that the device is connected to your WiFi.
But if you **need** to **change your WiFi connection**, or **forgot to save** the **PAK or Serial Number** for onboarding and registration on app.quakecore.com , the **Reset is the solution** you're looking for ✅
This way, the Quakecore-AP WiFi becomes visible again, and you can reconfigure your Quake miner.
To proceed, you must **press the Quake miner's reset button** at least **5 times** (when press reset button always do gently).\
Once you press the reset button, you will hear a beep and see one green light flash, then press the reset button again and so on.\
But **timing** is very important!\
You must press the reset button within around **2 seconds** of hearing the beep and green light of the previous one. **Repeat until you hear 2 consecutive beep**.
After you hear the 2 consecutive beep, please wait around 1 minute, this restore the setup stage and the **Quakecore-AP** should be **visible on WiFi again** 👍
After the Quakecore-AP is visible please redo the same configuration as it was a new quake miner, so from 192.168.4.1 to app.quakecore.com. Check here:
.png?alt=media&token=a816dbaa-dee9-4da8-954b-1defa28269b9)
.png?alt=media&token=93dc7f4a-b751-48b4-833a-5700e2001033)